We had to remove the engine, transmission, and sub-frame from the vehicle in order to change the timing chain and water pump. It was a big job. The customer had taken his car to a number of other shops who didn’t want to touch it. Here is the harmonic balancer.
We recently did a number of welding tasks to repair this cattle trailer. The cutting gate was in need of spot welding. Before: After spot welding the sheet metal on the cutting gate: We welded nuts to the edge of the sliding door to accept a locking pin . We welded a jack to the…
Installed new carburator and settling bowl. Cleaned fuel tank. Replaced points, condenser, and a leaky valve stem.
Cut out rusted sections and replaced them. Custom bent the high pressure line to fit. Brought in because the fuel lines were leaking gasoline.
